Nilfisk-ALTO FLOORTEC R 680 B, Руководство пользователя, Страница: 88 / 124

ENGLISH USER MANUAL
26 FLOORTEC R 680 B 1463516000(1)2008-05 A
SKIRT HEIGHT AND OPERATION CHECK
Preliminary procedure
Empty the hopper (as shown in the User Manual), because the weight of the waste inside the hopper can affect the skirt height 1.
check.
Drive the machine on a level
fl oor that is suitable for checking the skirt height. 2.
Engage the parking brake with the pedal (75) and the lever (68). 3.
Turn the ignition key (67) to “0”. 4.
Side skirt check
Release the fasteners (8 and 6), then open the right and left door (7 and 5). 5.
Check the side skirts (A, Fig. 19) for integrity. 6.
Replace the skirts when they have cuts (A, Fig. 20) larger than 20 mm or cracks/tears (B) larger than 10 mm (for skirt
replacement, refer to the Service Manual).
Check that the distance from the
fl oor of the side skirts (A, Fig. 19) is within 0 - 3 mm (see Fig. 21). 7.
If necessary, loosen the screws (B, Fig. 19) and adjust the skirt position. Then tighten the screws (B).
Front and rear skirt check
Remove the main broom as shown in the relevant paragraph. 8.
Check the front (A, Fig. 22) and rear skirts (B) for integrity. 9.
Replace the skirts when they have cuts (A, Fig. 20) larger than 20 mm or cracks/tears (B) larger than 10 mm (for skirt
replacement, refer to the Service Manual).
Check that the front (A, Fig. 22) and rear skirts (B) slightly rub on the
fl oor (see Fig. 24). 10.
If necessary, loosen the screws (C, Fig. 22) and adjust the skirt position. Then tighten the screws (C).
Press the front skirt lifting pedal (75) completely, and check that the front skirt lifts 5 cm approximately.
11.
Release the pedal and check that the skirt does not remain in an intermediate position but returns to its initial position. If
necessary, adjust the skirt lifting cable (A, Fig. 23) with the adjuster (B) on the left front side of the skirt (for the front skirt
control cable replacement, see the Service Manual).
Reset
Assemble the components in the reverse order of disassembly. 12.
P100232 P100233 P100234
Figure 19 Figure 20 Figure 21
P100235 P100236 P100237
Figure 22 Figure 23 Figure 24