Nilfisk-ALTO FLOORTEC 350, Руководство пользователя, Страница: 53 / 76

146 3083 000(2)2008-11 A
FLOORTEC 350 15
USER MANUAL ENGLISH
DUST FILTER CLEANING AND INTEGRITY
CHECK, HOPPER GASKET CHECK
Drive the machine on a level fl oor. 1.
Turn the main switch (1) to “0”. 2.
Remove the hopper (9). 3.
Loosen the knobs (A, Fig. 8). 4.
Grasp the dust fi lter (B) as shown in the fi gure. 5.
Remove the dust fi lter by turning it in the direction shown 6.
by the arrow (A, Fig. 9) to disengage it from the pins (B),
then lower the
fi lter to disengage it from the fi lter shaker
combs (C).
Remove the
fi lter (A, Fig. 10) from the frame (B) by 7.
disengaging the 2 rubber bands (C).
In an appropriate outdoor area, clean the
fi lter by shaking it 8.
on a level and clean surface, tapping the side (D) opposite
to the gasket (E).
Complete the cleaning procedure by using compressed air
(F) at maximum 6 Bar, blowing only from the side of the
gasket (E), at a minimum distance of 30 cm.
Check the
fi lter body for tears. If necessary, replace it.
For a better cleaning, it is allowed to wash the fi lter with
water and non-lathering detergents. This provides better
quality cleaning but reduces the life of the
fi lter, which
will have to be replaced more frequently. The use of
inadequate detergents can damage the
fi lter.
Clean the bearing surface of the fi lter rubber gasket 9.
(E) and check it for integrity and sealing capabilities. If
necessary, replace the
fi lter.
Clean the bearing surface of the hopper gasket (D, Fig. 10.
9) and check it for integrity and sealing capabilities. If
necessary, replace it.
Assemble the components in the reverse order of
11.
disassembly.
NOTE
Assemble the fi lter with the gasket (E, Fig. 10)
positioned as shown in the fi gure.
A
B
A
S311357
Figure 8
B
B
D
A
C
S311358
Figure 9
E
D
F
A
B
C
C
S311359
Figure 10
All Parts available from
www.sparesgiant.com
01772 329 565