146 3083 000(2)2008-11 A
FLOORTEC 350
13
USER MANUAL
ENGLISH
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
Check the main broom distance from the
fl
oor as shown
1.
below:
Drive the machine on a level
fl
oor.
•
Keep the machine stationary and turn on the main
•
broom for a few seconds.
Turn off the main broom by pressing the switch (1),
•
then move the machine.
Check that the main broom print (A, Fig. 3), along its
•
length, is 3-5 cm wide.
If the print is not within speci
fi
cations, adjust the broom
•
height as shown in step 2.
Turn the main switch (1) to “0”.
2.
On both sides of the machine, loosen the knob (A, Fig. 4).
3.
Grasp the support (B) on the points (C) and move it
4.
upwards, then lift it or lower it to change the main broom
height. For height variation, refer to the indicator (D). Then
tighten the knob (A) on both sides of the machine.
Perform step 1 again to check the proper adjustment of the
5.
main broom height.
When the broom is too worn to be adjusted, replace it as
6.
shown in the next paragraph.
CAUTION!
If the main broom print is excessive (larger than
5 cm), the machine regular operation is affected
and the moving or electrical parts can overheat,
thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
S311352
Figure 3
B
A
C
C
D
S311353
Figure 4
All Parts available from
www.sparesgiant.com
01772 329 565