Wheel System, Traction
231
Service Manual – Floortec R 870
Driver’s Seat Microswitch Disassembly/Assembly
Disassembly
1
Drive the machine on a level floor.
2 Turn the ignition key to “0” and engage the parking brake
3 Open the battery/engine compartment hood
Disconnect the battery connector (Floortec R 870 Battery) - Disconnect the batteries (Floortec R 870
Petrol/LPG)
4
On the lower side of the battery/engine compartment (A), remove the driver’s seat microswitch connector
(B) from its housing and disconnect it
5 Close the hood (A)
6 Move the seat (C) forward and remove it from the rails (D)
7 Retrieve the seat (C) with the wiring harness (E)
8
If necessary, remove the screws (F) and remove the seat rails (D).
Assembly
9
Assemble the components in the reverse order of disassembly, and note the following:
•
Before tightening the screws (F) check that the seat rails (D) are aligned
• After the seat have been reinstalled, check that it slides properly on the rails, and also check that it
engages properly in each position
D
D
C
E
F
A
B
F
F
F
P200212