General Information
8
Service Manual – Focus II / Scrubtec R6 Rider Autoscrubber
Transporting the Machine
Caution:
Before transporting the machine on an open truck or trailer, make sure that the machine
is tied down securely and all access doors and covers are secured (tape and strap as
needed).
The actual procedure for transporting the machine will vary depending on the mode of transport. Follow
these general guidelines as applicable to the situation.
• If the machine is not operational or cannot be
moved under its own power, you must manually
release the brake. To release the brake, move the
release handle
(27)
outward and insert an object,
such as a screw driver, behind the lever to keep it
deactivated.
•
Drain the recovery and solution tanks.
• If transport will occur below freezing temperatures,
place a small amount of environmentally friendly
antifreeze in the recovery tank, solution tank,
and solution lines. After transport, make sure to
dispose of the used antifreeze according to local
regulations.
•
Remove the squeegee from the machine (
). This is required to access the rear hold
down points and also protects the squeegee during
loading, unloading, and transport.
• If the loading, unloading, or transport operations
pose a risk for damage to the scrub deck, then
• Make sure the recovery tank is securely fastened
in place, or removed from the machine and
transported separately.
• Make sure the recovery tank cover is securely
held closed or removed from its hinges.
• Secure the machine to the transport using the
anchor points shown below.
General Machine Description
The Clarke Focus II Rider/Scrubtec 6 is a compact
battery power ride on floor scrubber. The machine
can be equipped with a 28 inch (71 cm) disc, 34 inch
disc, 28 cylindrical, 28 inch BOOST or 38 inch Disc
scrub deck. The machine may also be equipped with
an onboard detergent mixing system. This system
stores concentrated detergent on the machine and
meters the appropriate quantity of concentrated
detergent and mixes it on the machine with water from the solution tank. The machine can be equipped with
wet acid (flooded) or AGM (maintenance free) batteries and charged with either shelf or on board battery
chargers
27
Front Anchor
Points
Rear Anchor
Points
