12/2017
A - 27
56091204 - Nilfisk Liberty SC50
ENGLISH - A
INSTRUCTIONS FOR USE
6/2020
INSTALL THE PAD (REV SYSTEM)
1 Make sure the Scrub Deck is in the RAISED position. Make sure the Power Switch
(B)
is off.
CAUTION !
Turn the machine OFF at the power switch and remove the SmartKey, before changing the pad.
2
See Figure 2-5.
From the right side of the machine, rotate the Squeegee Assembly
(11)
towards the left side of the machine to create better
access to the pad,
(AA)
.
3
Daily Scrubbing:
Slide a daily scrubbing pad
(AE)
or Microfiber Pad
(AB)
under the pad driver, center it on the fixed pad driver
(AC)
and lift
it upwards and press it onto the harpoon face of the pad driver.
4
Floor Finish Removal:
Install a new red pad
(AE)
to the pad driver
(AC)
as described in step 3 above. If using the optional double sided
Velcro
(AF)
, attach it to the center of maroon SPP pad
(AD)
and slide this assembly under the red pad and center it and then press upwards
to attach this assembly to the red pad. If the optional double sided Velcro is not used, install a new red as described in step 3 above and
place a new maroon SPP pad on the floor centered on the red pad. Lower the deck to the floor on top of the maroon SPP pad and check that
it is centered.
NOTE:
Never attach a maroon SPP pad directly to the pad driver, damage to the pad driver will result requiring replacement.
FIGURE 2-5
AF
AB
11
AD
8
AC
AE
AA
