Nikon NPL-322, Инструкция по эксплуатации

Страница: 70 / 197

4 Applications
56 Total Station NPL-322 Instruction Manual
HA Reset and Angle Operations
To open the Angle menu, press
[ANG]
in the BMS. To
select a command from this menu, either press the
corresponding number key, or press
[<]
or
[>]
to highlight
the command and then press
[ENT]
.
Setting the horizontal angle to 0
To reset the horizontal angle to 0, press
[1]
or select
0-Set
in the Angle menu. The
display returns to the Basic Measurement Screen (BMS).
Entering the horizontal angle
To display the HA Input screen, press
[2]
or select
Input
in the Angle menu. Use the numeric keys to
enter the horizontal angle. Then press
[ENT]
.
Recording a foresight point after repeat angle measurement
1. To activate repeat angle measurement, press
[3]
or select
Rept.
in the Angle menu.
HR=0
appears.
2. Sight the backsight and press
[ENT]
.
3. Sight the foresight and press
[ENT]
.
The horizontal angle is accumulated and the
value is held again.
4. To end repeat angle measurement, press
[ESC]
.
5. When you have accumulated enough horizontal
angle between the backsight and the foresight,
press
[MSR1
] or
[MSR2]
to take a measurement to
the foresight.
F1 / F2 is not supported by the
NPL-322 5" single face model
.
To enter 123°45'50", type [1] [2] [3] [.] [4] [5] [5] [0] .
The displayed value is rounded to the minimum angle increment.