Nikon DTM-302 Series, Инструкция по эксплуатации

Страница: 71 / 222

Getting Started 3
Total Station DTM-302 Series Instruction Manual 53
If the signal level is insufficient to take a measurement, the signal icon flashes on
and off. For more information, see Status bar, page 29.
Measurement settings
31.3
To view the measurement settings,hold down
[MSR1] or [MSR2] for one second.
Use [^] or [v] to move the cursor between the fields.
Use [<] or [>] to change the value in the selected
field.
To change the height of target (HT), temperature,
or pressure, press
[HOT]
. For more information,
see [HOT] key, page 36.
Settings that relate to corrections
(T-P corr, Sea Level, C&R corr., and Map
projection) are included in the job settings. These
settings are job-specific. If you need to change
any of these settings, you must create a new job.
For more information, see Job settings, page 109,
and Settings, page 127.
Field Values
Target Prism
Sheet
Const (prism constant) –999 mm through 999 mm
Mode Precise
Normal
AVE (Average count) 0 (Continuous) through 99
Rec mode One of the following:
MSR only
Confirm
ALL