Nikon DTM-302 Series, Инструкция по эксплуатации

Страница: 33 / 222

Preparation 2
Total Station DTM-302 Series Instruction Manual 15
7. Insert the tripod mounting screw into the center hole of the base plate of the
instrument.
8.
Tighten the tripod mounting screw.
Note – Do not carry the instrument while it is attached to a tripod.
Centering
2.1
When you center the instrument, you align its central axis precisely over the station
point. To center the instrument, you can either use the optical plummet or a plumb
bob.
Centering using the optical plummet
21.1
Note – If you require high accuracy, check and adjust the optical plummet before
you center the instrument. For detailed instructions, see Checking and Adjusting the
Optical Plummet, page 161.
To center the instrument using the optical plummet:
1.
Set up the instrument on the tripod. For detailed instructions, see Setting Up the
Tripod, page 14.
2. While looking through the optical plummet, align
the reticle with the station point. To do this, turn
the leveling screws until the center mark of the
reticle is directly over the image of the station
point.
3.
While supporting the tripod head with one hand,
loosen the tripod leg clamps and adjust the lengths
of the legs until the air bubble is in the center of
the circular level.
4. Tighten the tripod leg clamps.
5.
Use the plate level to level the instrument. For detailed instructions, see
Leveling, page 16.
6. Look through the optical plummet to check that the image of the station point is
still in the center of the reticle mark.
7.
If the station point is off center, do one of the following:
– If the station point is slightly off center, loosen the tripod mounting screw
and then center the instrument on the tripod. Use only direct movement to
center the instrument. Do not rotate it.