325
n
Software
•
Capture NX 2
: A complete photo editing package with such
advanced editing features as selection control points and
an auto retouch brush.
•
Camera Control Pro 2
: Control the camera remotely from a
computer to take photos and save them directly to the
computer hard disk. When Camera Control Pro 2 is used to
capture photographs directly to the computer, a PC
connection indicator
c
will appear in the control panel.
Note
: Use the latest versions of Nikon software; see the
websites listed on page xvii for the latest information on
supported operating systems. At default settings, Nikon
Message Center 2 will periodically check for updates to
Nikon software and firmware while you are logged in to an
account on the computer and the computer is connected to
the Internet. A message is automatically displayed when an
update is found.
Wireless
remote
controllers
•
Wireless Remote Controller WR-R10/WR-T10
: When a WR-R10
wireless remote controller is attached to the camera
accessory terminal, the camera can be controlled wirelessly
using a WR-T10 wireless remote controller.
•
Wireless Remote Controller WR-1
: WR-1 units are used in groups
of two or more, with one functioning as a transmitter and
the remaining units acting receivers. The receivers are
attached to the accessory terminals of one or more
cameras, allowing the transmitter to be used to release the
camera shutters or adjust settings remotely.
Accessory
terminal
accessories
The Df is equipped with an
accessory terminal for
MC-DC2
remote cords
(
44) and
GP-1 and
GP-1A GPS units
(
connect with the
4
mark on the
connector aligned with the
2
next
to the accessory terminal (close
the camera connector cover when the terminal is not in use).