336
Image Sensor Cleaning
If you suspect that dirt or dust on the image sensor is appearing
in photographs, you can clean the sensor using the
Clean image
sensor
option in the setup menu. The sensor can be cleaned at
any time using the
Clean now
option, or cleaning can be
performed automatically when the camera is turned on or off.
❚❚
“Clean Now”
Holding the camera base down, select
Clean image sensor
in the setup menu,
then highlight
Clean now
and press
J
.
The camera will check the image sensor
and then begin cleaning.
1
flashes
in the control panel and other operations
can not be performed while cleaning is in
progress. Do not remove or disconnect
the power source until cleaning ends and
the setup menu is displayed.