E
69
Re
fere
nce
S
ecti
on
Error Messages
Display
Cause/Solution
A
Turn the camera off,
remove the lens cap,
and turn the camera on.
The lens cap may be attached, or a lens error has occurred.
Make sure that the lens cap has been removed, then turn the
camera on again. If the error persists even after the camera is
turned off and then on again, contact retailer or Nikon-
authorized service representative.
O
(flashes)
Clock not set.
Set date and time.
Battery exhausted.
Replace the batteries.
Q
(flashes in red)
Camera cannot focus.
•
Refocus.
•
Use focus lock.
Please wait for the
camera to finish
recording.
Wait until the image is saved and the message disappears
from the display.
–
Memory card is write
protected.
Write-protect switch is in “lock” position.
Slide write-protect switch to “write” position.
–
Not available if Eye-Fi
card is locked.
Eye-Fi card write-protect switch is in “lock” position.
Slide write-protect switch to “write” position.
–
Error accessing Eye-Fi card.
•
Check that terminals are clean.
•
Confirm that the card is correctly inserted.
This card cannot be
used.
Error accessing memory card.
•
Use approved card.
•
Check that terminals are clean.
•
Confirm that the card is correctly inserted.
This card cannot be
read.