54
Features That Can Be Set Using the Multi Selector
Sh
ooting Feat
ures
Flash Modes (Using the Flash)
You can set a flash mode that suits the shooting conditions.
1
Press
H
(
m
flash mode) on the multi selector.
2
Press the multi selector to select the desired
mode and press the
k
button.
•
information.
•
If the
k
button is not pressed within a few seconds,
the selection will be canceled.
•
When
U
(auto) is applied,
D
is only displayed for
a few seconds, regardless of
Photo info
settings
(
3
Frame the subject and take a picture.
•
The flash lamp indicates the status of the flash when
you press the shutter-release button halfway.
- On: The flash will fire when you press the shutter-
release button all the way.
- Blinking: The flash is charging. The camera cannot
take pictures.
- Off: The flash will not fire when a picture is taken.
•
If the battery is low, the monitor will be turned off
while the flash is charging.
C
Effective Range of the Flash
The flash has a range of about 0.3 to 3.5 m (1 ft to 11 ft) for wide-angle position, and about
0.5 to 2.2 m (1 ft 8 in. to 7 ft 2 in.) for telephoto zoom position (when
ISO sensitivity
is set to
Auto
).
F
l
ash
mode
Содержание COOLPIX AW100
