nifty HYBRID DC HR15N Series, Руководство по обслуживанию

Страница: 24 / 79

Service Manual
HR15/17N HYBRID DC
English 07/16
18
3.1.3 Engine Oil Replace
ENSURE ENGINE IS OFF BEFORE DRAINING THE ENGINE OIL.
WHEN DRAINING ENGINE OIL, PLACE A CONTAINER UNDERNEATH THE ENGINE
AND DISPOSE ACCORDING TO LOCAL REGULATIONS.
DO NOT DRAIN OIL AFTER RUNNING THE ENGINE, ALLOW ENGINE TO COOL
DOWN SUFFICIENTLY.
1) Remove the drain plug located on the underside of the engine and drain the oil into a suitable
container. Note; This will be easier if the oil is warm.
2) Replace seal ring and reinstall drain plug.
3) Tighten drain plug. See section 2.6 for torque settings.
4) Top up engine oil to the upper limit of the dipstick. Oil type can be found in the oil specification table.
See section 2.4.2.
5) Re-check oil level at least 5 minutes after filling engine.
3.1.4 Engine Oil Filter Replace
ENSURE ENGINE IS OFF BEFORE REPLACING THE ENGINE OIL FILTER.
PLACE A CONTAINER UNDERNEATH THE ENGINE OIL FILTER AND DISPOSE ANY
WASTE ACCORDING TO LOCAL REGULATIONS.
ALLOW ENGINE TO COOL DOWN SUFFICIENTLY PRIOR TO REPLACING THE
ENGINE OIL FILTER.
1) Using a filter wrench or strap, remove the
engine oil filter (1).
2) Replace oil filter, apply a film of oil to the seal
of the oil filter. Ensure oil filter is marked with
the Niftylift’s hours and date of filter change.
3) Screw engine oil filter onto engine by hand.
When seal contacts the seal surface, tighten
by hand. Do not tighten with filter wrench.
4) Run engine for a short period and check for
leaks.
5) Wait 5 minutes and check the engine oil level.
1