INTERNAL SYSTEMS
12V WIRING SYSTEM
The 12V internal wiring system is used to power the following devices:
- cooler
- water pump
- gas boiler
- interior lighting
and other devices adapted to 12V voltage.
12V voltage is obtained from the power supply unit or from the car battery.
The system is connected to the vehicle with a 13-pin connector according to
ISO 11446
230V WIRING SYSTEM
To turn on the electrical power supply:
NOTE !:
1. Never use portable cooking appliances or heaters other than
electric heaters that are not sources of direct thermal radiation due
to the risk of fire or suffocation.
2. Never allow unqualified persons to modify electrical systems and
equipment (230V and 12V).
GAS SYSTEM
- connect the caravan to an external 230V power supply (using an
extension cord)
- plug the power supply unit into the 230V socket next to the power supply
unit
- switch on the residual current circuit breaker (located next to the power supply)
List of light bulbs used in the internal system
-17-
Fig. 8. Gas installation diagram.
-18-
front halogen lamp overhead
halogen lamp
G4 12V/20W halogen lamp
side halogen lamp rear halogen
lamp (N126n)
G4 12V/10W halogen lamp
bathroom lamp (N126nt)
12V/5W fuse
1.
Gas cylinder (not supplied).
2.
W40 rubber hose (optional).
3.
Reducer suitable for operation at
30mbar (optional).
4.
8x1 coated steel or copper tube.
5.
Valves.
6.
Gas stove.
7.
Cooler (optional).
8.
Heater (optional).
9.
Strait joint.
10. Angle joint.
