THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
Customer Support: 1.800.668.9318
Email: [email protected]
Web: www.nienkamper.com
PAGE 1 OF 2
With the table top upside down on a protective surface, align base
through holes with threaded inserts in top. Be sure to position the
base so the actuator cable and release tab face center inserts.
Fix base assembly in place using 1/4”-20 x 9/16” Joiner Bolts.
Install Shoulder Bolts into center threaded inserts. Be sure to
position the actuator cable behind Shoulder Bolts with Tab facing
out.
Align thru holes in Actuator Cover with pilot holes in top. Position
cover with Actuator Tab sticking out through notch and fi x with #8
x 5/8” pan head wood screw.
Center inserts
METRONOME FLIP TOP TABLE
INSTALLATION GUIDE
4mm Hex Key
Philips Screwdriver / Bit
Drill
Wire
Management
Clip
#8 x 5/8”
Pan Head
Wood Screw
1/4”-20 x 9/16”
Joiner Bolt
HARDWARE:
TOOLS REQUIRED:
SUGGESTED MINIMUM CREW: 2
APPROXIMATE INSTALL TIME: 30 min.
Shoulder
Bolt
Ganging Clip &
Thumbscrew
Actuator
Cable Cover
Modesty Stop
Bracket
