BA
W
-ALS 50X35_50X55 01/20 GB
Niedax GmbH & Co. KG -
Asbacher Straße 141 - D-53545 Linz/Rhein
Tel.: +49 (0 26 44) 56 06-0 - fax: +49 (0 26 44) 56 06-13 - [email protected] - www.niedax.de
oPeRATIoN
Firstly the positions of the notches are marked on the side walls of the surface metal raceway.
The notch, produced by the complete unit, has a height of 35 mm respectively 55 mm and
a length of 50 mm. The cover of the surface metal raceway is removed and no cables and
foreign objects etc. are located in the area of the notching tool.
The nut (2.2) of the notching tool has to be fully loosened to open the notching tool. The mo-
vable punch (2.3) is thereby the furthest from the mould (2.4). Now the notching tool can be
inserted over the side wall into the surface metal raceway. Afterwards the nut (2.2) has to be
manually tightened up to the stop in order to minimalize the distance between the punch (2.3)
and the mould (2.4) and in order to create a tight fit between the notching tool and the side
wall of the surface metal raceway (see Figure 04 and 05).
Is the required notch at the end of the surface metal raceway, the entire tool can be inserted
from the side (lengthwise) as well.
In any case, attention must be paid to tighten the nut (2.2) up to the stop in order to minimali-
ze the distance between the punch (2.3) and the mould (2.4) before operating the tool.
5
/8
2.2 Nut
2.3 Punch
2.4 Mould
1.5 Reset lever
1.3 Battery
1.6 Handle
1.4 Operating Switch
2. Notching tool
1. Basic unit (hydraulic punch)
1.1 Head of the basic unit
figure 03
