Nidek Medical SE-9090 Supra, Руководство по обслуживанию

Страница: 209 / 350

LLE7D*RDA002B
197
3 ) Enter the value with the numeric keypad, then press the Enter key .
4 ) Press [Exit] to return to the layout screen.
6 . Confirm the lens measurement axis (see 8.13.2.1 [p195]) .
7 . Repeat the adjustment until the trace and
marking-off line on the measurement trac-
ing confirmation jig (40396-M021) are par-
allel.
8 . After adjustment, press [Exit] to return to the layout screen.
1 ) Perform the following.
2 ) Backing up the EEPROM data
(See 8.19.1 [p284].)
8.14 Processing Adjustment
1 . Change the size on the layout screen by the procedure below so that a single lens can be
processed several times.
1 ) For the ø45 internal data, enter the value obtained by adding 9.00 mm to the Size
value on the layout screen.
2 ) For the

45 internal data, enter the value obtained by adding 6.00 mm to the Size
value on the layout screen.
2 . From the second processing and later, change the size by the procedure below.
1 ) For beveling, enter the value obtained by subtracting 4.00 mm from the Size value on
the layout screen.
2 ) For flat edging, enter the value obtained by subtracting 3.00 mm from the Size value
on the layout screen.
3 . Enter the parameter values in the following increments.
1 ) Enter the size or position parameter values in 0.01 mm increments.
2 ) Enter the axis parameter value in 0.1º increments.
Caution However, if a size is specified in the adjustment procedure, follow it.
/
Trace
Pliable
cup