SI-Ethernet User Guide
11
Issue: 3
Sa
fety
Int
rodu
cti
o
M
El
Ge
tting
P
Ke
y f
PC T
Se
cu
Di
G
In
2.4
Factory fit Ethernet interface identification
As standard, the
Unidrive M700
and
Unidrive M702
variants are fitted with an Ethernet interface
and the
Unidrive M701
is fitted with the EIA-485 serial communications interface.
Care must be taken to ensure the correct interface is fitted before a connection is made to the drive,
failure to ensure this may result in damage to the interface and/or communication device.
The Ethernet and EIA 485 interfaces are similar in appearance but the differences are:
•
The Ethernet interface will have the Ethernet communication logo
on the front of the
panel with the appropriate port number below it. It also has a LED located below each
connector.
•
The EIA 485 port just has the number "485" printed alongside it.
2.5
Product conformance
The Ethernet interface complies with IEEE 802.3 and meets the isolation requirements of safety
standard EN50178:1998.
2.6
Conventions used in this guide
The configuration of the host drive and option module is done using menus and parameters. A
menu is a logical collection of parameters that have similar functionality.
In the case of an option module, the option module set-up parameters in menu 0 will appear in
drive menu 15, 16 or 17 depending on which slot the module is installed in. In the case of the
onboard Ethernet interface, the set-up parameters in menu 0 will appear in drive menu 24.
The setting of the Option Slot Identifiers (Pr
11.056
) may change the slot numbering from those
described above. The internal menus of the option module or onboard Ethernet interface will
appear before menu 0 and after menu 41.
The method used to determine the menu or parameter is as follows:
•
Pr
S.mm.ppp
- Where
S
signifies the option module slot number and
mm.ppp
signifies the
menu and parameter number respectively.
If the option module slot number is not specified then the parameter reference will be a drive
parameter.
•
Pr
MM.ppp
- Where
MM
signifies the menu allocated to the option module setup menu and
ppp
signifies the parameter number within the set-up menu.
•
Pr
mm.000
- Signifies parameter number 000 in any drive menu.
2.7
Firmware Statement
This product is supplied with the latest firmware version. When retro-fitting to an existing system, all
firmware versions should be verified to confirm the same functionality as products of the same type
already present. This also applies to products returned from a Nidec Industrial Automation’s
Service Centre or Repair Centre. If there is any doubt please contact the supplier of the product.
The firmware version of the product can be identified by looking at Pr
MM.002
where
MM
is the
relevant menu number for the module slot being used.
For Unidrive M200, M300 and M400 drives, the option module set-up parameters will
appear in menu 15.
NOTE
Содержание Unidrive M600
Страница 1: ...User Guide SI Ethernet and Unidrive M Onboard Ethernet Part Number 0478 0137 03 Issue 3 ...
Страница 16: ...16 SI Ethernet User Guide Issue 3 Figure 4 3 Typical network topologies ...
Страница 215: ......
Страница 216: ...0478 0137 03 ...