Nidec DT-3015N, Инструкция по эксплуатации

Страница: 6 / 41

4
2.2 Charging
Be sure to charge the battery before initial use.
Before charging, be sure to check that the power is turned OFF.
Please check the state of the power switch OFF with the picture in
“3.1 Main unit” on page 6.
2.2.1 Charging method
Turn the power OFF, and connect the AC adapter's connector to the main unit.
Next insert the AC adapter's AC plug into an outlet. The battery lamp lights up, and charging starts.
Charging is complete in approximately 2 hours, and then the charging lamp goes off.
The battery lamp( B-CHG ) State
Off AC adapter not connected, or Charging complete
Flash Charging error (Stop charging)
Continuous light Charging
*Be sure to use the supplied AC adapter.
*Use at the ambient temperature 15°C or higher.
(If the ambient temperature is lower than 15°C, Charging may not be possible.)
*If the battery overheats, a charging error may occur.
In this case, let the internal temperature decrease and then reconnect the AC adapter.
Note 1) When the power is turned ON during charging, charging is canceled and emission starts. When the unit uses
the AC adapter as its power source, it is not charged. (Note that emission and charging cannot be performed
simultaneously.)
Note 2) Though the unit can be charged while battery power still remains, charging will still end when fully charged.
It is recommended, however, that the unit be charged when the battery has run out ("LLLLLL" is indicated on
the display) to avoid reducing the battery life itself.
Note 3) If the unit is charged immediately after a long emission time at a high ambient temperature,the temperature
detection circuit will turn on, and the charging lamp may not light up. In that case, disconnect the AC adapter,
and let the unit cool. When the product temperature has decreased, connect the AC adapter again and start
charging.
Note 4) Using in a high temperature environment may shorten the battery life.
Remove the connector cover,
and connect the AC adapter
Never charge the unit under the following conditions.
Adapter of
another device
・
Using another AC adapter than supplied
・
Charging near flammable materials
Oil