Compatible Housings
NICOR’s MAXCOR 5” and 6” Recessed LED Downlight will work with most 5 inch and 6 inch housings. The
MAXCOR 5” & 6” Recessed LED Downlight has a built in trim and does not require any additional trim. Use
in recessed housings with no open holes.
This LED retrofit kit is intended for installing in the field in
recessed type IC luminaires with dimensions outlined in the
installation instructions.
Minimum height for 6 inch cans is 7.5 in. (19cm). Minimum
height for 5 inch cans is 7.75 in. (19.6cm).
Suitable for wet locations in covered ceiling mount luminaires.
The retrofit kit is accepted as a component of a luminaire
where the suitability of the combination shall be determined by
CSA of authorities having jurisdiction.
For a selection of NICOR Housings, please visit our website:
www.nicorlighting.com
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393
Doc. Rev. 8-11
™
5” & 6” Recessed LED Downlight
Installation Instructions for the MAXCOR
5” & 6” Recessed LED Downlight
Model# NSSLR-1-3-14-56-W
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393
Risk of Fire or Shock
. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not
qualified, do not attempt installation. Contact a qualified electrician.
Risk of Fire or Shock
: Supply conductors (power wiring) connecting the fixture must be rated minimum 90
0
C. If
uncertain, consult an electrician.
Risk of Electric Shock
: Disconnect power at fuse of circuit breaker before installing or servicing.
Risk of Fire or Electric Shock:
Install this kit only in the luminaires that has the constructions features and
dimensions shown in the photographs and/or drawings.
Risk of Fire or Electric Shock:
Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
Risk of Fire or Electric Shock:
Do not alter, relocate, or remove wiring, lampholders, power supply, or any other
electrical component.
Risk of Fire or Electric Shock:
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects.
CAUTION
: To avoid possible electric shock, be sure that power supply is turned off at fuse box or circuit breaker
before attempting installation or servicing of the fixture. For safest operation read and become familiar with
complete installation instructions prior to use.
WARNING
!
MAXCOR 5” & 6” Recessed LED Downlight
7.5in (190.5mm)
3.78in
(96mm)
Torsion spring
