NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com June 21, 2021 8:36 AM
EML7
LED High Output Emergency Light
INSTALLATION INSTRUCTIONS
Model: EML71UNVWH
What’s In The Box
One (1) EML7
WARNING
before beginning. All electrical connections must be in accordance with local codes, ordinances, and the National Electric Code. If
- Do not use outdoors.
- Do not let power supply cords touch hot surfaces.
- Do not mount near gas or electric heaters.
local codes.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not use this equipment for other than its intended use.
- The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
- Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
- Operating temperature: 0°C - 40°C.
Tools Needed
A Phillips screwdriver will be needed to install the
EML7. A drill is helpful to remove the knockouts and
mounting holes.
1
Installing the EML7
Figure 1 -
Wiring Diagram
Preparation
• Carefully unpack the emergency light from its
packaging. Inspect product for defects due to
shipping.
• Become familiar with the wiring diagram before
beginning installation.
•
2
• Remove the center knockout and mounting holes on
the back plate by drilling or cutting out.
• Feed the power supply through the knockout.
• Mount the back plate to the junction box with
appropriate hardware.
• Connect the power supply (120/277 VAC) to the input
wires, using the provided wire nuts, according to the
wiring diagram in Figure 1
• Connect the battery to the LED board.
•
snap into place.
Mounting and Installation
NOTE
Battery Testing: Allow 24 hours of charging before testing.
•
Push In TEST Button - Fixture will switch to battery power and remain lit
•
Release TEST Button - Fixture will switch back to AC power
