Nibe FIGHTER 1127, Инструкция по установке и обслуживанию

Страница: 9 / 36

Available information and on-display settings
FIGHTER 1127 has a two-line LCD display. The heat pump
can be set via this display and its associated buttons.
Channel selection
The ”Channel” button lets you browse through the following
display modes to find the information you require.
Values within brackets are also described within brackets.
If a value is programmable, this is denoted by a [P] (Program-
mable) in front of the value.
If the next value cannot be changed, you can access the next
menu by pressing ”Channel”.
Setting
The first step when changing a value is to press the ”In-
crease” button once. A cursor (line) then appears under the
value. The value can then be increased or reduced using the
”Increase” or ”Reduce” buttons.
NOTE
Enter the selected values on page 2 of this Installation
instruction. The details are important for service work.
1
WW-out 47(52) °C
Hot water 48 °C
In normal mode, the above information appears on the LCD
display of the heat pump.
WW-out:
Current flow temperature
(Calculated flow temperature.)
Hot water
Indication of the hot water temperature.
2a
Outdoor -14 °C
Room 20.5 (20)°C
Outdoor
Current outdoor temperature.
Room
Current room temperature. Only shown if a room sensor
is connected
[P] (Target value set on room sensor.)
Setting range: 5 – 30 °C.
2b
Outdoor -14 °C
Room-comp 4
This menu is a submenu of menu 2a and is activated by
positioning the cursor under the value for "Outdoor" and
then pressing the "Channel" button.
Room comp.
This menu applies to heating mode
[P] When the room temperature differs by 1 °C change
the set point value WW-out with the indicated value.
A higher value gives a quicker reaction to excess or low
indoor temperatures. The normal value for a radiator sy-
stem is 4.
Setting range: 0 – 6 °C
3
Start C 25 °C
Start H 20 °C
Start C
Start temperature for cooling function.
Setting range: 22 - 30°C (outdoor temperature).
With connected room sensor: If the room temperature
exceeds the set value by more than the set value in menu
19, cooling mode starts automatically, independent of
Start C.
Default setting is 25 °C.
Start H
Start temperature for heating function.
Setting range: 10 - 22 °C (outdoor temperature).
Default setting is 20 °C.
7 FIGHTER 1127
For Home Owners
Control