SAFETY, ENVIRONMENTAL, AND REGULATORY INFORMATION
PXIe-1487
FlexRIO GMSL Interface
Read this document before you install, configure, operate, or maintain this product. Users are required to familiarize themselves with installation and wiring
instructions in addition to requirements of all applicable codes, laws, and standards. Visit
for more information about your product, including
specifications, pinouts, and instructions for connecting, installing, and configuring your system.
Regulatory Icons
Notice
Take precautions to avoid data loss, loss of signal integrity, degradation of performance, or damage to the product.
Caution
Take precautions to avoid injury. Consult the product documentation for cautionary statements when you see this icon printed on the
product. Cautionary statements are localized into French for compliance with Canadian requirements.
Safety
Caution
Observe all instructions and cautions in the user documentation. Using the product in a manner not specified can damage the product and
compromise the built-in safety protection. Return damaged products to NI for repair.
Attention
Suivez toutes les instructions et respectez toutes les mises en garde de la documentation d'utilisation. L'utilisation du produit de toute autre
façon que celle spécifiée risque de l'endommager et de compromettre la protection de sécurité intégrée. Renvoyez les produits endommagés à NI pour
réparation.
Safety Compliance Standards
This product is designed to meet the requirements of the following electrical equipment safety standards for measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CSA C22.2 No. 61010-1
Note
For safety certifications, refer to the product label or the
Product Certifications and Declarations
section.
EMC Guidelines
This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications.
These requirements and limits provide reasonable protection against harmful interference when the product is operated in the intended operational
electromagnetic environment.
This product is intended for use in commercial and light-industrial locations. However, harmful interference may occur in some installations, when the product
is connected to a peripheral device or test object, or if the product is used in residential areas. To minimize interference with radio and television reception and
prevent unacceptable performance degradation, install and use this product in strict accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by NI could void your authority to operate it under your local regulatory
rules.
EMC Notices
Refer to the following notices for cables, accessories, and prevention measures necessary to ensure the specified EMC performance.
Notice
For EMC declarations and certifications, and additional information, refer to the
Product Certifications and Declarations
Notice
Changes or modifications to the product not expressly approved by NI could void your authority to operate the product under your local
regulatory rules.
Notice
The performance of this product can be disrupted if subjected to Electrostatic Discharge (ESD) during operation. To prevent damage,
industry-standard ESD prevention measures must be employed during installation, maintenance, and operation.
Notice
Operate this product only with shielded cables and accessories.
Notice
The length of all I/O cables must be no longer than 15.0 m (49 ft).
