NF ZM2371, Инструкция по эксплуатации

Страница: 218 / 255

7.1 Error Messages
7-5 ZM2371/ZM2372
7.1.4 Errors in Remote Control
This section describes main errors that occur in the remote control.
Error
No.
Error message Cause
0 No error
－－－
-100 Command error Command is not correct. (No detailed classification)
-102 Syntax error Unrecognizable command or data was received.
-104 Data type error The format of parameter is improper.
-108 Parameter not
allowed Too many parameters are used, or a parameter is used
in illegal position.
-109 Missing parameter The number of parameters is deficient.
-110 Command header
error Command header is not correct.
(No detailed classification)
-113 Undefined header Undefined command header is used.
-120 Numeric data error Numeric data is not correct.
(No detailed classification)
-130 Suffix error Suffix (multiplier, unit) is not correct.
(No detailed classification)
-140 Character data error Character data is not correct. (No detailed classification)
-144 Character data too
long Character data is too long ( > 12 characters).
-150 String data error Character string data is not correct.
(No detailed classification)
-200 Execution error Command cannot be executed.
(No detailed classification)
-211 Trigger ignored Trigger was received but could not be executed.
-221 Settings conflict Command could not be executed due to the restriction
between plural settings.
-222 Data out of range Data is out of allowable range.
-241 Hardware missing Command cannot be executed because hardware to be
operated is not installed.
-300 Device-specific error Command cannot be executed because of device-specific
internal error. (No detailed classification)
-310 System error Device-specific internal error occurred.
(For instance, loss of memory data)
-330 Self-test failed An error was found in the self-test.
-350 Queue overflow The error queue overflows, and it cannot retain new
error.
-363 Input buffer overrun The input buffer overflows.
-410 Query
INTERRUPTED Response to query was interrupted by the subsequent
command.
-420 Query
UNTERMINATED Response was requested before reception of query is
completed.
-430 Query
DEADLOCKED Processing cannot be continued because of full buffer.
-440 Query
UNTERMINATED
after indefinite
response Response is not correct because there is another query
after the query that requests arbitrary length response.