NF ZM2371, Инструкция по эксплуатации

Страница: 142 / 255

5.4 Command List
5-15 ZM2371/ZM2372
5.4 Command List
ZM2371 / ZM2372
commands are separated into the common commands defined by
IEEE488.2 and subsystem commands that reflect device-specific functions.
The
ZM2371 / ZM2372
has different command systems depending on the operation mode.
This section describes standard operation mode. For other operation modes, see
“6. Change
of Operation Mode”
.
Common commands that
ZM2371 / ZM2372
provides are listed in
Table 5-2
. Also, subsystem
commands of
ZM2371 / ZM2372
are listed in
Table 5-3
.
The meaning of codes used in
Table 5-2
and
Table 5-3
are explained below. It is possible to
omit the keywords lowercase character parts.
•
Keywords shown in square brackets ([ ]) are those that support omission. (implicit
keyword)
•
The vertical bar ( | ) indicates the possibility to select a keyword from several keywords.
Table 5
–2 Common command list
Command Name Function
*CLS
Clear Staus Command
Clears status data
*ESE
*ESE?
Standard Event Status
Enable Command /
Query Sets/queries the standard event status enable
register.
*ESR?
Standard Event Status
Register Query Queries the standard event status register contents.
*IDN?
Identification Query Queries the device identification information (model
name etc).
*OPC
*OPC?
Operation Complete
Command / Query Requests to set the Standard Event Status register’s
OPC bit to 1 when all command operations are
completed. In response to query, it returns 1 when
all operations are completed.
*OPT?
Option Identification
Query Queries the built-in options.
*RCL
Recall Command
Recalls the contents of specified settings memory.
*RST
Reset Command Resets the device and initializes the settings.
*SAV
Save Command Saves current settings in the specified settings
memory.
*SRE
*SRE?
Service Request Enable
Command / Query Sets/queries the service request enable register.
*STB?
Read Status Byte Query Queries the status byte.
*TRG
Trigger Command Applies a trigger to execute measurement once when
the trigger source is BUS and the device waits for a
trigger, and reads the measured data when
measurement finished.
*TST?
Self-Test Query Queries the self test result.
“0” (no error) is returned, if normal.
*WAI
Wait-to-Continue
Command Waits for executing the following commands until all
of the preceding command operations are completed.