NF ZM2371, Инструкция по эксплуатации

Страница: 129 / 255

5.1 Preparations Before Use
5-2 ZM2371/ZM2372
5.1 Preparations Before Use
ZM2371
can be remote controlled by USB or RS232.
ZM2372
can be remote controlled by GPIB, USB and RS232.
By sending program messages from the controller it is possible to control the device
similarly to panel operations and to receive measured values or setting status as response
messages.
The connectors of respective interfaces are located on the rear panel of the
ZM2371 /
ZM2372
.
5.1.1 Remote Control Interface Selection
The
ZM2371 / ZM2372
use either one of USB, RS-232, and GPIB as a remote control
interface. Plural interfaces cannot be used at the same time.
The setting of remote control interface is made from the system setting menu.
_ SHIFT _ + [ SYSTEM ]
Press the
_ SHIFT _ + [SYSTEM]
keys to display the system setting menu.
S Y S T E M s e t t i n g s
0 ) I N T E R FA C E 1 ) B E E P E R > N E X T
Options (first page)
Select INTERFACE with the
_ 0 _
key, and the remote control interface setting menu is
displayed.
I N T E R FA C E : U S B
Current setting
0 ) U S B 1 ) R S - 2 3 2 2 ) G P I B
Options
USB Selects USB (initial value) and displays the USB confirmation screen.
RS-232 Selects RS-232 and displays the RS-232 setting menu.
GPIB Selects GPIB and displays the GPIB address setting menu.
Select either one with a numeric key.
For the
ZM2371
, however, GPIB is not displayed as an option and cannot be selected.
Perform the EXIT operation to return to one-previous menu.
_ SHIFT _ _ EXP _ | [SYSTEM]