NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 82 / 330

4.4 Setting for Main Items
WF1967/WF1968
4-32
4.4.7 To Set the Synclator Function
Select [Synclator] and press the ENTER key
to turn the Synclator function on or off.
Frequency of waveform output and external
signal added to TRIG IN will synchronize
when the Synclator function is on.
In this case, the phase difference between the
added external signal and the output signal
can be freely adjusted in the [Phase] settings.
The [Freq] item cannot be changed when the Synclator function is turned on and the current oscillator
frequency will be displayed. Synchronization is possible across a range from 20Hz to 10MHz. Loss
of synchronization can be checked by the [UnLock] status area in the upper right hand corner of the
screen.
This function cannot be used in sweep mode, the FM/FSK/PSK modulation mode, or burst oscillation
modes other than auto burst mode.
In the WF1968, the external trigger input of channel 1 may be used to act as the synchronization
source for channel 2. Set the Synclator synchronization source [SyncSrc] on page 2 (page 3 when
using auto burst) to the [Ch1] instead of [Ext].
Check
It is not the case that if the phase setting is 0° that the phase difference between the
added external signal and the output signal will be 0°.