NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 131 / 330

4.8 Setting and Operation of Sweep
WF1967/WF1968 4-81
Continuous sweep

When [Off] is selected
The output will be low level. This helps to reduce interference from synchronization output signal.
r) To assign a marker value for a center value, or to assign a center value for a marker
value
When the soft-key [Ctr
⇒ M kr] is presse
d on the second page, a center value is assigned for a marker
value. When the soft-key [Mkr
⇒ Ctr] is pressed, the
center value. If these soft-keys on the second page of the setting screen are not displayed, press the
right end soft-
key [▼1/2] to toggle the soft-key set.
s) To control the sweep start, stop and pause with an external logic signal
Set the external control [ExtCtrl] to enable [Enable] on page two of the setting screen to conduct
sweep operations with a TTL level logic input to the Multi I/O connector on the rear panel. This is
shared by CH1 and CH2.
It is recommended that this be set to disable [Disable] when not using an external control signal in
order to avoid malfunctions caused by exogenous noise. For pin number assignment,

P.3-16
The following operations can be performed.

Sweep start (pin 14)
Falling input to pin 14 starts the sweep. The sweep will restart from the beginning even if it is
already running.
In the case of a single sweep or a gated single sweep, the sweep will start from the beginning when
a trigger is received. The operation is a logical sum with the trigger source that is set.

Sweep stop (pin 13)
Falling input to pin 13 stops the sweep, and the output returns to the sweep start value.
However, in the case of a single sweep or a gated single sweep, the sweep will start from the
beginning when a new trigger is received.

Sweep hold/resume (pin 12)
Falling input to pin 12 holds the sweep if it is running. If the sweep is temporarily stopped, it will
restart from the hold position.
However, if a new trigger is received while a single sweep or gated single sweep is temporarily
Start value
Sweep value
Sweep
sync signal
SwpSync
(marker disabled)
Sweep
sync signal
S Mkr
(marker enabled)
Sweep X drive
Signal
Stop value
Stop value
Start value
Marker value
One way
Marker value
Shuttle
Sweep time Sweep time Sweep time
Low at
first
half
Low from
start to
marker Low from
start to
marker
Low from
start to stop
Low from
start value
to marker
value