NF DP060LM, Инструкция по эксплуатации, Страница: 89 / 307

4.2 Using Sequence Function
DP060LM/DP120LM/DP180LM
71
Table 4-1 Wattage Limiter Value per Phase (Reference value)
Rated output
（
Unit
：
VA
）
Single-phase
Limiter Value
（
Unit
：
W
）
Single-phase
three-wire
Limiter Value
（
Unit
：
W
）
Three-phase
Limiter Value
（
Unit
：
W
）
Numb
er
of po
wer units
per phase
DP060LM
1 2000 2100 2100 2100
2 4000 4200
 
3 6000 6300
 
DP120LM
1 2000 2100 2100 2100
2 4000 4200 4200 4200
3 6000 6300
 
4 8000 8400
 
5 10000 10500
 
6 12000 12600
 
DP180LM
1 6000 6300 6300 6300
2 12000 12600
 
3 18000 18900
 
--------
Notes ------------------------------------------------------------------------------------------------------------
 If the wattage limiter operates, suppress the output wattage within the rated output power by
lowering the output voltage setting value.
 Active power (unit: W) is restricted by the wattage limiter, however, reactive power (unit: var)
is not restricted. Therefore, the apparent power (unit: VA) may exceed the rated power
depending on the power factor of the load. Set the output voltage so that the apparent power
does not exceed the rated power, regardless of the operation of the wattage limiter.
 The value of the wattage limiter cannot be changed. To limit the output power to a value that is
lower than the rating, decrease the number of power units that are energized through the power
unit energization setting, or use the peak current limiter or the RMS current limiter.
-----------------------------------------------------------------------------------------------------------------------------
4.2 Using Sequence Function
4.2.1 Basics
By using Sequence function, an output setting can be changed step-by-step according to the program
(sequence) created beforehand. This section describes the basics for using the Sequence function.
  AC/DC Mode and Signal Source
Sequence function keeps the selection of the AC/DC mode and a signal source, independently from
Continuous function/Simulation function. AC/DC mode can be selected from AC/ACDC/DC. A
signal source is fixed as INT.