NF DP060LM, Инструкция по эксплуатации, Страница: 289 / 307

11.25 Memory Function
DP060LM/DP120LM/DP180LM
271
11.25 Memory Function
You can save basic settings (AC/DC mode, signal source, output range, AC setting, DC setting,
current limiter, setting range limit, etc.) for each output phase configuration in the non-volatile Basic
Setting Memory of No.1 to No.30, and recall them to use when the output is off. The No.1 setting is
restored at power-on. The No.0 setting includes the setting items for the factory default.
The external control, display, and other settings are saved in non-volatile System Setting Memory
when they are changed by the panel operation or remote command.
The Sequence, Simulation, clipped sine wave, and arbitrary wave are saved in their own non-volatile
memories.
Items in the Basic Setting Memory *62
Factory default
Output range 100 V range
AC/DC mode AC mode
Signal source INT
External synchronization signal (LINE or
EXT)
LINE
AC voltage setting 0 V
Frequency 50 Hz
Output waveform Sine wave
Output on phase and output off phase 0.0°
Phase voltage/Line voltage setting
selection
Phase voltage
Phase angle setting Single-phase three-wire: 180°
Three-phase four-wire: 120°, 240°
Balanced/Unbalanced Balanced
DC voltage setting
0 V
Current limiter
See 11.14
Setting range limit
See
11.15
External input gain
100 / 200
*62 ： Some items do not exist depending on the AC/DC mode or signal source.
Items in the System Setting Memory
Factory default
Output function Continuous
DC offset setting 0 mV
Measurement display mode Normal View
Measurement unit selection rms
Power unit energization setting All enabled (energization)
Output phase configuration Single-phase two-wire
Remote sensing Off
AGC Off
General function
See 11.24 (excluding the time unit setting of the Step Time
for the Sequence and Simulation)
Monitor output target Current (L1 phase)
External interface USB
External control Disabled