NF DP060LM, Инструкция по эксплуатации, Страница: 271 / 307

11.7 DC Output
DP060LM/DP120LM/DP180LM
253
*9 ： Can be set only in the polyphase output.
*10 ： In the case of 10 V to 150 V/20 V to 300 V, sine wave, no load, 45 Hz to 65 Hz, DC voltage setting
0 V, 23 °C

5 °C.
*11 ： If the output voltage is higher than the rated value, this is limited (lowered) to satisfy the power
capacity. In the case of 40 Hz or lower or 400 Hz or higher, and that the ambient temperature is
40°C or higher, the maximum current may decrease.
*12 ： For the capacitor input type rectified load (crest factor=4 or 3), the rated output voltage, and 45 Hz
to 65 Hz.
*13 ： In the case rated output voltage, 50 Hz or 60 Hz. If the output voltage is higher than the rated value,
this is limited to satisfy the power capacity. It may reduce short reverse power flow if ambient
temperature is 40°C or higher or repeated interval of reverse power flow is 15 minutes or less.
*14 ： External power injection or regeneration which is over short reverse power flow capacity is not
available.
*15 ： For 45 Hz to 65 Hz, the rated output voltage, no load and the resistance load for the maximum
current, and the operating temperature.
*16
：
For 40 Hz to 550 Hz, sine wave, the rated output voltage, the resistance load for the maximum
current at 55 Hz, and 55 Hz reference.
*17
：
Set for the L1 phase. The component of the phase angle setting is added for the other phases.
*18
：
In the case of 50 V or higher, sine wave, and same load condition and voltage setting for all phases.
*19
：
In the case of the AC mode and 23 °C

5 °C.
11.7 DC Output
[V]=Vdc, [A]=Adc, unless otherwise noted. The polarity is relative to the Lo terminal.
Single-phase output
DP060LM DP120LM DP180LM
Mode Floating output, the Lo terminal can be grounded.
Rated output voltage 100 V / 200 V
Voltage setting range

227.0 V to +227.0 V /

454.0 V to +454.0 V
Setting resolution 0.1 V
Voltage accuracy
*20

(|0.5 % of set| + 0.6 V / 1.2 V)
Maximum source
current *21
60 A / 30 A 120 A / 60 A 180 A / 90 A
Maximum
instantaneous source
current
*22
Peak value (Apk) which is four times of the
maximum current
Peak value (Apk) which
is three times of the
maximum current
Short sink current
*23
100 % or less of Maximum source current
(reverse power flow time
≦
20 ms, discontinuous, 40 °C or lower)
Power capacity 6 kW 12 kW 18 kW
*20
：
In the case of − 212 V to − 10 V, +10 V to +212 V / − 424 V to − 20 V, +20 V to +424 V, no load, AC
setting 0 V, 23°C

5°C.