NF DP060LM, Инструкция по эксплуатации, Страница: 266 / 307

11. Specifications
PROGRAMMABLE AC POWER SOURCE 248
Specifications are valid under the following settings and conditions and after a warm-up period of
30 minutes at least, unless otherwise noted.
Load
Resistance load of power factor 1
Signal source INT (internal signal source)
Output voltage waveform Sine wave
Remote sensing Off
AGC/Autocal Off
Current Limiter
Factory default setting
[set] indicates a setting value, and [rdg] indicates a read value.
The description noted with "/" indicates that the specification changes by the output range, such as
"100 V range specification/200 V range specification."
The input voltage is noted as line voltage in three-phase four-wire input, unless otherwise noted.
A value with the accuracy is the guaranteed value of the specification. However, an accuracy noted
as reference value shows the supplemental data for reference when the product is used, and is not
under the guarantee. A value without the accuracy is the nominal value or representative value
(shown as typ.).
The product corresponds to Clause 2 (8) Frequency converter, Appendix 1 of Export Trade Control
Ordinance. The permission for exportation of the Japanese Administration is necessary for export
outside Japan.
11.1 Output phase Configuration
Single-phase output Polyphase output
Output phase
Configuration
Single-phase two-wire
Single-phase two-wire,
Three-phase four-wire (Y-connection)
11.2 Output Function
Single-phase output Polyphase output
Output Function Continuous, Sequence, Simulation
11.3 Output Range
Single-phase output Polyphase output
Output Range 100 V range, 200 V range