NF DP060LM, Инструкция по эксплуатации, Страница: 123 / 307

4.3 Using Power Fluctuation Testing (Simulation) Function
DP060LM/DP120LM/DP180LM
105
4.3.2 Simulation Function Parameters
Table 4-4 shows the parameters of Simulation function. The common parameters are common to one
simulation. In the Simulation function, the signal source is fixed to INT sine wave and the ACDC
mode to ACDC mode. When in polyphase, the balanced mode is always used. In each step, set the
step-control parameter and the intra-Step parameter. As for intra-Step parameter, the range that can be
set differ depending on the output range (100 V/200 V range) as in the case of Continuous function.
Table 4-4 Simulation Function Parameters
Common
parameter
Step-control parameter Intra-Step parameter
Output range
AC/DC mode
(Fixed to ACDC)
Waveform
(Fixed to sine
wave) Step Time
Start Phase
Stop Phase
Trigger output
Step sync code output (2bit)
Repeat count (1 to 9999 or infinite) Frequency
AC voltage
 Relationship between each step and settable Step parameters
定常 1
移行
1
異常 移行
2
定常
2
T1 T2 T3 T4 T5
S1 S2 S4 S3 S5
トリガ出力
同期出力
V1, F1
V3, F3
V1, F1
電圧・周波数は
正常
1 と同じ
Voltage and
frequency are
same as
Normal 1
Trigger output
Sync output
Normal1 Normal2 Abnormal Trans1 Trans2
Figure 4-11 Simulation Function Steps