Security
Clicking
Configure Network > Security
takes you to the
Password Configuration
page, which lets you set
passwords for the administrator-level (ADMIN) and user-level (USER) accounts.
Figure 3-158:
Password Configuration
page
Administrator and User access
The
Administrator access
and
User access
sections display the following information:
Current “ADMIN”/“USER” login password requirements
: Indicates whether a password is currently
required for the ADMIN or USER account, respectively.
Change “ADMIN”/“USER” login password requirement to
: Used to enable or disable password
protection. Select
NOT Required
(the default) to disable password-protected login. Select
Required
to
enable password-protected login.
Login user name is fixed to
: Displays the account user name: ADMIN or USER.
Current Password
: Enter the current account password to make changes. If password-protected login is
currently disabled for this account, this item is not displayed.
New Password
: Enter the new account password.
Passwords should be between eight and 16 characters, can contain both letters and numbers, and are
case sensitive.
E-Series V/VT models running firmware version R011.1206.3 or later, and E-Series P models running
firmware version S011.1300 or later can also use these special characters:
! $ % & ' ( ) * + , - . < > [ ] ^ _ ` { | } ~
Chapter 3: The Graphical User Interface — Configure Network
Nexsan High-Density Storage
User Guide
218