Newtec 3X00 Modem Guide
11
The table below describes the Sensor Outputs relevant to this module
Item
Description
Newtec Detected Noise
A measure of unwanted signal power used for calculating the
actul received signal level
Newtec Min Lock Signal
An automatically generated sensor output not used in this
Module
Newtec Min Valid Signal
An automatically generated sensor output not used in this
Module
Newtec Rx. Lock
Flag that indicates whether Newtec unit has declared carrier lock.
Newtec Rx. Sig.
Signal level value as read from Newtec modem.
Newtec Signal Average
Readout of average signal as read from AAQ
Newtec Signal Gradient
Mathematical approximation of signal change over time in
coordination with “Newtec Gradient Sample Time” configuration
item as read from AAQ.
Module Windows
4.3.
4.3.1.
Device Window
The software provides a Device Window for use in monitoring operation. To check that configuration has been
completed successfully, on the AAQ Remote GUI, go to
View
Device Window
and ensure that the Connection
Status reads “Connected”. Once configured properly, the modem should connect to the AAQ in less than a minute.
If this time is exceeded, double check all configuration items and physical connections.
Path
Main Window → View→ Device Window
Level 0
Figure 11 – Device Window
