NewLine SHUB Screen Скачать руководство пользователя страница 2

Страница: 2 / 5

STEP ONE: Install Canister and Extrusion with End Caps

1. Draw a straight line along tub edge where you would like to position your rail.

2. Place

on left or right side of shower with handle facing outward (HANDLE IS THE LATCH

DEVICE). Position the rail end cap at the edge of your pencil line. Use a level to ensure

vertical. Peel off tape from

as shown, and press firmly against wall.

3. Position

with the lower rail end cap

at the edge of your pencil line. Use level to ensure

is vertical. Peel off tape from

, and press firmly against wall.

• 2 •

www.newlinebathroom.com

TAPE

NOTE:

DO NOT REMOVE

PART C

UNTIL

PART D

IS INSTALLED

RAIL END

CAP ON

THE LINE

RAIL END CAP

(

PART C

) ON

THE LINE

Содержание SHUB Screen

Страница 3: ...1 4 Transfer measurement to each and cut to measured lengths 2 Slide the upper slider inside the track and push into the rail end cap Unclip the UPPER rail end cap from place on to and clip it back in place 3 Repeat for LOWER rail 3 www newlinebathroom com A D B B B C C B B D D B B B B RAIL END CAP PART C A C C ...

Страница 4: ...STEP THREE Caulk 1 Caulk the exterior perimeter of the SHUB Screen Allow caulk to dry Enjoy your SHUB Screen The Intelligent Shower Screen 4 www newlinebathroom com ...