Message Intersect & Pack
nlscan.com
Page 105
Message Intersect
2D, Program Intersect Option
A command input consists of 3 or 6 decimals.
The first input is for barcode format; Refer to
“
Symbologies ID Number
”
. The second input is for
intersecting direction;
“
000
”
denotes ascending and
“
001
”
denotes descending. The following 2 inputs are for
start digital and end digital.
Start digital and end digital value consist of 4 digits: thousand, hundred, decimal, figure. And they are
programmed by 6 digits:
“
0
”
, thousand, hundred,
“
0
”
, decimal, figure. For example, program 001013 for 113.
For example, intersect QR Code from 1st digit to 20th ascending and from 113th digit to 140th ascending.
1. Read
“
Code Programming ON
”
2. Read
“
Allow Intersection
”
3. Read
“
Program Intersect Option
”
4. Check Symbologies ID Number table for QR Code
5. Read digit barcodes in the bellow
0 3 3
0 0 0
0 0 0 0 0 1
0 0 0 0 2 0
0 0 0
0 0 1 0 1 3
0 0 1 0 4 0
symbology ID
ascending
the 1st digit
the 20thdigit
descending
the 113th digit the 140th digit
How to clear a certain 2D barcode Intersection Setting?
E.g: If you want to cancel the QR Code Intersection Settings, take the processing as below;
Read
“
Enable Code Programming
”
bar code first
1.
Read
“
Clear a barcode Intersection setting
”
2.
Check Symbologies ID Number table for QR Code as
“
003
”
3.
Read corresponding number barcode below
4.
Read
“
save
”
and
“
Disable Code Programming
”
codes
5.
Rules:
1. Maximum intersect 3 barcode message sections
2. Maximum value is 9999 for start digital and end digital
3. Overlaps of barcode message sections are allowed and work independently.
4. Start digital and end digital determine its message section sequence. In the above example, descending
“
004
”
and
“
001
”
determine the section sequence to be
“
reciprocal 4th
”
,
“
reciprocal 3rd
”
,
“
reciprocal
2nd
”
,
“
reciprocal 1st
”
5. to intersect only one digit, program start digital and end digital to be the same value
