6
Chapter 2 System Settings
Factory Defaults
Scanning the following barcode can restore the scanner to the factory defaults.
You may need to reset all parameters to the factory defaults when:
1. Scanner is not properly configured so that it fails to decode barcodes;
2. you forget previous configuration and want to avoid its impact;
3. functions that are rarely used have been enabled for the time being.
Restore All Factory Defaults
Illumination
A couple of illumination options are provided to improve the lighting conditions during every image capture:
Normal
(default): Illumination LED is turned on during image capture.
Always On
: Illumination LED keeps on after the scanner is powered on.
Off
: Illumination LED is off all the time.
Off
** Normal
Always On
Содержание NLS-HR20-RF
