** Enter Setup
Exit Setup
94
Set Length Range for Code 128
The scanner can be configured to only decode Code 128 barcodes with lengths that fall between
(inclusive) the minimum and maximum lengths.
The supported maximum length is 255 characters. If minimum length is set to be greater than maximum
length, the scanner only decodes Code 128 barcodes with either the minimum or maximum length. If
minimum length is same as maximum length, only Code 128 barcodes with that length are to be decoded.
Set the Minimum Length
Set the Maximum Length
Example: Set the scanner to decode Code128 barcodes containing between 8 and 12 characters
1. Scan the
Enter Setup
barcode.
2. Scan the
Set the Minimum Length
barcode.
3. Scan the numeric
barcode “8”. (See the
Digit Barcodes
section in Appendix)
4. Scan the
Save
barcode. (See the
Save/Cancel Barcodes
section in Appendix)
5. Scan the
Set the Maximum Length
barcode.
6. Scan the numeric barcodes
“1” and “2”.
7. Scan the
Save
barcode.
8. Scan the
Exit Setup
barcode.
Содержание NLS-HR1050-7 Series
