Newland NLS-FM515 Series, Руководство пользователя

Страница: 143 / 162

Enter Setup
133
** Exit Setup
Chapter 14 Batch Programming
Introduction
Batch programming enables users to integrate a batch of commands into a single batch barcode.
Listed below are batch programming rules:
1. Command format: C Parameter Value.
2. Each command is terminated by a semicolon (;). Note that there is no space between a command and its terminator
semicolon.
3. Use the barcode generator software to generate a 2D batch barcode.
Example: Create a batch barcode for Illumination Always On , Sense Mode , Decode Session Timeout = 2s:
1. Input the commands:
@ILLSCN2;SCNMOD2;ORTSET2000;
2. Generate a batch barcode.
When setting up a scanner with the above configuration, scan the Enable Batch Barcode barcode and then the batch
barcode generated.
Enable Batch Barcode