Newland NLS-FM420, Руководство по интеграции

Страница: 22 / 199

nlscan.com Page 12
Introduction
There are 3 ways to program (con fi gure) the scanner, Code Programming, Command Programming, and
QuickSet Programming.
Code Programming
The scanner reads a set of specially encoded barcodes to program features. In the following sections, we will
explain the options and features available and provide the barcodes to program them.
This method of programming the scanner is most straight forward. However, it requires manually readings of
each barcode. As all manual operations, errors are more likely to occur.
Command Programming
The Host can send the Pro CMD strings (see the chapter of Software Interface) to program the scanner. In the
following sections, the Pro CMD strings will be included with the barcodes for Code Programming.
A
fi xture, such as EVK3000 or other simplier circuit board, could be used to program the scanners before
they are installed into your equipments or systems. Another alternative is to design the con fi guration
capability in your equipments or systems.
This method of programming the scanner could be automated. A software program can be developed to
download all the con fi guration data to the scanner.
QuickSet Programming
QuickSet is a Windows based GUI program for Newland Auto-ID bar code readers. It displays decoded data
and captured images. The scanner with its circuit board can be easily con fi gured through the interface of
QuickSet.
This method of programming the scanner is similar as the Command Programming. QuickSet is a software
program developed for Newland Auto-ID products .
Note: The programming results are restored in non-volatile memory. They will not be lost when the scanner
is powered off.
Programming the Scanner