Enter Setup
**
Exit Setup
28
Chapter 6 Beep & LED Indications
Introduction
Besides communication output, the engine can also generate a PWM signal and a pulse signal. Those
outputs in conjunction with external circuits are able to drive the beeper/LED indicator.
This chapter describes how to program the beep/LED notification feature.
Startup Beep
If startup beep is enabled, the engine will beep after being turned on.
**
Enable Startup Beep
Disable Startup Beep
Good Read Beep
The engine can be configured to beep after good decode. Beep type (frequency) and volume (duty circle
of PWM) are also user programmable.
** Good Read Beep On
Good Read Beep Off
Содержание NLS-EM2045 Series
