nlscan.com
Page 57
Symbols
Tools
Code Programming ON
Code Programming OFF
UCC/EAN-128
1D bar code Message Length should not exceed 255 bytes. If Max Message Length is
less than Min Message Length, it means the engine will only support barcodes of the two
lengths. If Max Message Length is equal to Min Message Length, the engine will only sup-
port barcodes of the length.
To set Min Message Length of UCC/EAN-128 to 8 bytes and Max Message Length to 12
bytes, read these programming codes
“
Code Programming ON
”
1
、
“
Select Min Message Length
”
2
、
Digit Code
“
8
”
, see Digit Code
3
、
“
Save Programming
”
, see Digit Code
4
、
“
Select Max Message Length
”
5
、
Digit Code
“
1
”
6
、
Digit Code
“
2
”
7
、
“
Save Programming
”
8
、
“
Code Programming OFF
”
9
、
Select Message Length
It is used to program the valid reading length of UCC/EAN-128. The engine
will send an error beep, if the decoded data length does not match the valid
length.
UCC/EAN-128 Message Length is de
fi
ned by
“
Min. Message Length
”
and
“
Max. Message Length
”
.
Min Message Length
【
Pro CMD
:
99910103
】
Max Message Length
【
Pro CMD
:
99910104
】
Содержание NLS-EM1300
Страница 1: ...NLS EM1300 1D Barcode Scanning Engine Integration Guide Version 1 0...
Страница 16: ...nlscan com Page 7 Introduction Mechanical Interface This section describes theMechanical Interface...
Страница 136: ...nlscan com Page 127 Revisions Version Data Source Description Date Approved Pre release version 20090826...