【
Enter Setup
】
29
**
【
Exit Setup
】
Sense Mode
The scanner waits for the image stabilization timeout to expire before activating a decode session every
time it detects a change in ambient illumination. Decode session continues until the barcode is decoded
or the decode session timeout expires.
In the Sense mode, a trigger pull can also activate a decode session. The decode session continues until
the barcode is decoded or the trigger is released. When the session ends, the scanner continues to
monitor ambient illumination.
【
Sense Mode
】
Decode Session Timeout
This parameter sets the maximum time decode session continues during a scan attempt. It is
programmable in 1ms increments from 1ms to 3,600,000ms. When it is set to 0, the timeout is infinite.
The default setting is 3,000ms.
【
Decode Session Timeout
】
Set the Decode Session Timeout to 1,500ms:
1. Scan the
Enter Setup
barcode.
2. Scan the
Decode Session Timeout
barcode.
3.
Scan the numeric barcodes “1”, “5”, “0” and “0”. (See the
Appendix
)
4. Scan the
Save
barcode. (See the
Appendix
)
5. Scan the
Exit Setup
barcode.
Содержание HR3260-CS
