Nexus CT SIP®
Quick Start Guide
For complete installation information, please visit
www.mtnproducts.com/guides/nexusct
Water dispense button
Auto Clean Setup
• Press and hold SIP button. You will hear
1
short beep; continue holding
until you hear
1
long beep (about
7
seconds after initially pressing the
button.) This will activate the auto clean setup mode and white light
around the “Water” dispense button will start to flash.
• Release the button after hearing the long beep.
• Press the SIP button “X” number of times for the number of hours from
the current hour that you want the auto clean to start (
1
press equals
1
hour; maximum of
24
.) You will hear a beep with each button press.
Then press the “Water” dispense button to accept the setting (you will
hear a long beep and the white blinking light ring will turn off.)
‣
For example, if the current time is
12:00
p.m. and you want the
SIP auto clean to start at
12:00
a.m., press the SIP button
12
times; if you want it to start at
2:00
a.m., you would press it
14
times.
•
The system automatically exits setup mode if the water
dispense button is not pressed within
15
seconds of pressing
auto clean button. Pressing any other buttons other than SIP
auto clean or water dispense will exit set up mode.
SIP button
Back of Unit
®
