NRP1002/P IP Phone User Manual
www.newrocktech.com 24/68
Talking
When the call is connected, user will see a talking mode screen as the following figure.
Figure 37 - Talking Mode Screen
1. Audio Channel
–
The icon reflects the current audio channel being used.
2. Remote Party
–
The name or number of the remote party.
3. Talking time
–
The time passed since the call established.
4. Screen Pages
–
The number of screen pages. User can press up/down navigation buttons to switch
screen page.
Call Holding /Resuming
User can hold the remote party by pressing [Hold] button and the button will be changed to [Resume] icon.
User can press the [Resume] button to resume the call.
Figure 38 - Call Holding Screen
Call Ended
When user finished the call, user can put the handset back to the device to hang up the call or press the
hands-free button to close the audio channel to hang up.
NOTICE! When the call is held or in holding state, the user must press [Resume] button to back to call
mode, or putting the handset back to the device or pressing Speaker-free button to hang up is not
available.
6.1.1
Make / Receive Second Call
The device can support multichannel concurrent calls. When there is already a call established, user can still
answer another incoming call on either lines or make a second call on either lines.
Second Incoming Call
When there is another incoming call during talking a phone call, this call will be waiting for user to answer it.
User will see the call message in the middle of current screen. The device will not be ringing but playing call
waiting tone in the audio channel of the current call and the LED will be flashing in green. User can accept or
