New Leader NL345/MULTAPPLIER, Руководство оператора

Страница: 137 / 142

- 137 -
NL345
www.NewLeader.com
(800) 363-1771
312884-AA-C
Test Procedure
Using the data sheets supplied with the kit, document all spreader information and adjustments as
necessary� See Figure 1�
Rev. Spreader Model:
Site: Serial No.
Date:
Time: Conveyor Type:
Material Name:
in.
Density: Feedgate Height:
in.
Crush Strength:
SGN:
CFR/Constant:
Wind: From at MPH
%
Temperature:
°F
lbs/acre
Spinner Speed:
RPM
Controller Vehicle Speed:
MPH
Controller Swath Width:
1330 76th Ave SW
Cedar Rapids, IA 52404-7052
(319) 363-8281
SPREAD PATTERN DATA SHEET
New Leader Manufacturing
6
7 7
1
NLM
10/07/2016
MAP
65
6
324
320
780
12
.232
3"
1-2-1-2
3.25
#4 BOC
432165
L4000G4
67
90
Straight
41%
5
10am
Figure 1
Select an area for testing measuring at least 120 feet x 200 feet (37 m x 61 m), and with a slope of less than
two degrees�
All testing should be done when the wind velocity is less than 5 MPH (8�05 km)� If wind is present, testing
must be done with spreader traveling parallel (within ± 15 degrees) to the wind direction�
Do not allow loaded spreader to sit for more than one hour prior to testing�
At this stage of testing, drive the spreader over the collection trays in ONLY ONE DIRECTION�
Insert a plastic grid into each of the 23 collection trays� Position the blue collection tray in the center of the
spreader’s path with the longest dimension of the tray parallel to the direction of travel. Position the first
left-hand and right-hand trays 10’ (3m) from center, and all subsequent trays on 5’ (1�5m) centers�
Spread Pattern