New Leader AGCO NL4258, Руководство оператора

Страница: 104 / 134

- 104 -
www.NewLeader.com
(800) 363-1771
312521-AA-C
NL4258/4330G4 EDGE
Boundary Spreading
NOTE:
This program allows the operator to independently modify spinner speeds to change the width of
spread to either side, creating a “boundary” line to maximize spreading efficiency.
• On the Run Screen, press to access
spinner settings�
1� Enter spinner offset:
• The Spinner Settings screen will appear� To create a
Boundary, use the keypad to enter a specific Spinner
Offset� Spread pattern tests should be completed
for each product to be spread to determine best
offset settings, based on density, crush strength and
size� See “Spread Pattern” section for details� Press
to save and return�
2� Enable boundary spreading:
• When running normally, Run Screen will display all
swath sections normally� To activate the Boundary,
flip the spinner switch on the switch box to the side
that the boundary is on�
• EXAMPLE: If spreading with a boundary to the right
hand side in relation to direction of travel, flip the
switch to the right to limit the spread pattern on the
right hand side�
• When Boundary is activated, Run Screen will display
with the outer swath section darkened on the
boundary side (right hand boundary activation shown)�
Controller Operations