New Holland WORKMASTER 35, Руководство оператора

Страница: 143 / 180

7 - MAINTENANCE
Fuel injectors - Bleed
Bleeding the injector lines
Bleed the injector lines if:
• The tractor has run out of fuel.
• New injectors have been installed.
• The injection pump has been removed for service
repairs.
WARNING
Escaping fluid!
Hydraulic fluid or diesel fuel leaking under
pressure can penetrate the skin and cause
infection or other injury. To prevent personal
injury:
Relieve all pressure before discon-
necting fluid lines or performing work on the
hydraulic system. Before applying pressure,
make sure all connections are tight and all
components are in good condition. Never use
your hand to check for suspected leaks under
pressure. Use a piece of cardboard or wood
for this purpose. If injured by leaking fluid, see
your doctor immediately.
Failure to comply could result in death or seri-
ous injury.
W0178A
WARNING
Burn hazard!
Exhaust surfaces are hot! Always wear protec-
tive gloves when cleaning or working on the
muffler, catalytic converter, or exhaust stack.
Failure to comply could result in death or seri-
ous injury.
W0329A
To bleed the injector lines:
1. Loosen the injector line fittings, (1) , at the injectors.
2. Move the hand throttle control lever to its wide open
position.
3. Crank the engine until air-free fuel flows from each con-
nection, then tighten the fittings to 24 - 29 N·m ( 18 -
21 lb ft ).
NOTICE: If air is not purged from the system, repeat the
above procedures. Do not crank the engine continuously
for more than 30 seconds as this may cause starting motor
failure.
NHIL12CT00788AA
1
7-35